The automatic baler has good rigidity and stability, beautiful appearance, convenient operation and maintenance, safety and energy saving, and low investment cost of equipment basic engineering. The automatic baler is widely used in various waste paper mills, old materials recycling companies and other enterprise companies. It is suitable for packing and recycling old waste paper and plastic straw, which is good for improving labor efficiency, reducing labor intensity, saving manpower and reducing transportation costs. device.

The automatic baler can be automatically packaged by the principle of wrapping the product or package with a plastic strap, then tightening the machine with both ends fused by thermal effects. The function of the automatic baler is to make the plastic belt adhere to the surface of the bundled package, to ensure that the package is not scattered during transportation and storage, and should be bundled neatly and beautifully.

Today, let's talk about the reason why the automatic baler is not in place.

The automatic baler feeding belt is not in place and the quality of the belt is related. We must ensure the straightness, hardness and skewness of the belt to be small. It is related to the friction and resistance of the place where the belt passes.

1) The capacity of the storage bin is too small, and there is entrainment in the storage bin.

2) There is a phenomenon of head splitting.

3) The fixing screws on the roadway are loose, the flaps are not flexible, or the belt is too dirty.

4) The force of the lever spring is too large or too small.

5) The position of the ejector clearance is not adjusted.

6) When the machine is stopped, the right top knife is lifted up, and the zero position is not allowed when the machine is stopped.

7) Feed the probe ahead or lag.

8) The bottom of the belt is lower than the height of the center abutment.

9) The T-shaped guide or slide is not reset. The swinging spring of the T-shaped guide plate is fatigued by the spring, resulting in a slower return of the T-shaped guide.

10) The belt is worn and retracted, or the roller shaft is detached, the eccentric shaft is worn, or the bearing is broken.

11) The front and rear covers are worn, or the installation position is improper and the rollers are worn.

12) The cassette block is stuck with dirt.

13) The delivery time is not long enough.

14) The belt of the motor belt is too loose or broken.